Last modified: 2024-06-15 by ian macdonald
Keywords: australia | air force ensign | stars: southern cross | southern cross | roundel | kangaroo (red) | stars: seven points |
Links: FOTW homepage |
search |
disclaimer and copyright |
write us |
mirrors
image by Clay Moss, 27 Nov 2007
Flag proclaimed 6 May 1982; Ratio 1:2
See also:
The current RAAF Ensign is a "light blue Australian ensign" with the southern cross tilted and the RAAF roundel featuring a leaping kangaroo in the lower fly.
Jonathan Dixon, 17 April 2003
In 1981 the RAF roundel on the RAAF Ensign was changed into the red kangaroo roundel. The new design was approved by HM the Queen in 1981 and [proclaimed under] the Flags Act on 6 May 1982.
(Sources: [vau83], the Ausflag website and an article on the ABS site)
Miles Li, 17-18 April 2003
Because the Southern Cross on this ensign is tilted clockwise, the individual stars appear to have one point down and two points up.
Miles Li, 21 February 2005
The Gazettal of "The Royal Australian Air Force Ensign" on 6 May 1982 states:
"the Southern Cross as a whole is angled away from the fly with the "Gamma Crucis" positioned as for the Australian National Flag and "Alpha Crucis" positioned 1/6 of the width of the fly from the middle line of the fly and 1/6 of the width of the fly from the bottom edge."According to my geometry, this results in an angle of rotation of approximately 14.036 degrees from the vertical.
The 1982
Proclamation by the Governor-General, Sir Zelman Cowen, is scanned into the
RAAF website as a single page. The Schedule describes the modified Crux &
roundel in a single, wordy paragraph that is basically unreadable. However it
is correct.
Its 2008 re-proclamation on Comlaw (F2008L00202) is
accompanied by an Explanatory Statement that includes the wordy paragraph
mentioned above, with several words of the first sentence altered to refer
back to the 1982 original. However later in the paragraph two separate lots
of text, amounting to about two lines worth, have been omitted. The missing text is part of the description of the RAAF roundel dimensions.
Jeff
Thomson, 27 April 2012
image by Clay Moss, 27 Nov 2007
Ratio 1:2
The 'Flags of Australia' chart [vau83] said that the new RAAF ensign was approved by King George VI in December 1948 to replace the RAF Ensign in use in Australia since 1922. Similar information can be found in the Ausflag website. The most authoritative source is on the Australian Bureau of Statistics site, an article contributed by the former Department of the Special Minister of State. It says that the southern cross and commonwealth star were added "in the same positions as on the Australian Blue Ensign". The result is a "light blue Australian ensign" with the cross tilted and the RAF roundel added in the lower fly. The flag was actually adopted by the RAAF in 1949.
Miles Li and Jonathan Dixon, 17-18 April 2003
Although the current version is a Section 5 Flag of Australia, proclaimed in
1982 (& again in 2008), it's predecessor was not. The 1948 RAAF Ensign was
approved by the King, but the flag does not appear to have been gazetted in
Australia, nor is there an actual introduction date. It seems to have been
purely an item of military regalia.
Jeff Thomson, 26 April 2012
In the flag exhibition at the York International Congress of Vexillology there were also two Australian
Air Force Ensigns on display (Collection C. Moss). One was the
current version from 1982. The other one was very interesting, insofar as it had a reverse
different from the obverse. The obverse showed the old pattern (1948-82)
with the "British" roundel, the reverse the new pattern (1982-) with the
kangaroo roundel. Does anyone know when or if this version was used?
M. Schmöger, 11 November 2001
This flag was again proclaimed under Section 5 on 25 January 2008, with effect from 1 January 2008. The Legislative Instruments Act 2003 required the original to be lodged in a Federal Register, and due to an administrative oversight it was not, and the proclamation was automatically repealed. The new proclamation simply corrected that oversight.
The other 4 flags previously afforded the same status were re-proclaimed at the same time (the Defence Force Ensign proclamation needed to be back-dated further to 1 October 2006). One consequence of the Legislative Instruments Act, apart from the unintended repeal of the original proclamations, is to make all current legislative instruments enabled by the Flags Act available through the register at the
Attorney-General's Department Federal Register of Legislation site.
Jonathan Dixon, 23 June and 1 October 2008
The other surprise is that the seven-pointed stars on the Royal Australian Air Force Ensign are very irregular. Also the shades of blue and red aren't the same as the White Ensign and the white is actually a bluey grey.
Graham Bartram, 24 June 2008
The written description of the Ensign is also less detailed than that in the original proclamation.
Jonathan Dixon, 24 June 2008
image by Clay Moss, 29 June 2010
Seen in a pub in Bali, this RAAF ensign hanging on the wall. It looked
to be maybe 18 x 36 inches. The flag resembles the old 1948-82 Royal Australian
Air Force flag/ensign, except the (British) Royal Air Force roundel has replaced
the federation star.
Clay Moss, 29 June 2010
image by Martin Grieve
Ratio 1:2
From National Archives (PRO) AIR 2/211, on 24 July 1922: "Royal Air Force Ensign approved without difference as the Ensign of the Royal Australian Air Force."
David Prothero, 18 April 2003
Until 1948, the RAF ensign was used.
Miles Li, 7 July 1999
The NAA file can be accessed online from
https://recordsearch.naa.gov.au/SearchNRetrieve/Interface/ViewImage.aspx?B=7649240,
and is an attachment to Air Board Agenda No 106, with date given as > 1 July
1921.
The article on the ensign at the
RAAF website says "With the formation of the Royal Australian Air Force on
31 March 1921, as the successor to the Australian Flying Corps which had been
established by the Australian Army in 1913, it was decided to have an Ensign
which could reflect the national identity of our military aircraft and would
include a distinctive roundel. However, while a specific RAAF Ensign was
formally approved by Air Board and the then Minister for Defence on 10 August
1921, it was not processed for Royal approval. Consequently, the RAF Ensign was
adopted without change by the RAAF and was flown until 1948."
Jeff
Thomson, 24 October 2012
image by Ralph Kelly, 24 October 2012
The 1922 RAAF Air Council is illustrated in Elizabeth Kwan's "Flag and
Nation" at page 83 [kwa06]. I drew the illustrations for Elizabeth's
book, including this flag.
Ralph Kelly, 24 October 2012
According to The Australian Experience of Air Power (p.36, published
by the Air Power Development Centre, 2013, PDF available at
https://airpower.airforce.gov.au/publications/aap1000-h-australian-experience-air-power-2nd-edition,
the ensign proposal was submitted by the first Chief of Air Staff, Richard
Williams, on 21 July 1921.
Jonathan Dixon, 17 September 2014
The same source also mentions that the service was still the Australian Air
Force at the time, with the "Royal" being added on 13 August 1921. However, the
proposal is explicitly for the Royal Australian Air Force. Apparently, this
proposal was in anticipation of the name change.
Peter Hans van den
Muijzenberg, 17 September 2014
The RAAF Manual of Ceremonial, AAP 5135.002, which is downloadable at this Air Cadet Corps site, gives details on the use of flags in the RAAF. The Australian national flag is flown at all times on RAAF establishments on its own pole at wing or group headquarters; it is never flown on an RAAF flag mast (i.e., a nautical-style mast with gaff and crosstree).
The RAAF ensign is flown from the gaff of the flag mast until sunset, or after sunset as well if flyng operations are still in progress, the ensign is spotlighted, and the lights do not interfere with operations.
Within Australia, the Australian national flag may be carried with the RAAF ensign if RAAF troops are parading with foreign troops who are carrying their own national flag. Outside Australia, RAAF troops parade with an RAAF ensign flanked by two Australian national flags. On these occasions, the national flag and RAAF ensign are mounted on staffs 2.6 m long tipped with 15 cm silver-colored spearheads.
"Under no circumstances are Colours overseas to be paraded or placed with the Australian National Flag or the RAAF Ensign."
At courts martial, the RAAF ensign and Australian national flag are both displayed in synthetic silk "suitably fringed and tasselled" mounted on crossed pikes. Same display in offices of senior officers.
The Australian national flag and RAAF ensign are folded as follows:
However, the section of the manual on funerals provides for US-style folding
of the flag into a triangle at such occasions. This applies to either the
Australian national flag or the RAAF ensign used to cover the casket.
Joe McMillan, 23 November 2003
Found at http://recordsearch.naa.gov.au/SearchNRetrieve/Interface/ViewImage.aspx?B=3386292:
Fifty Australian air ensigns of the Volunteer Air Observers Corps, an
air force auxiliary corps, were ordered on 10 July 1945. Perhaps they were never
issued as the Corps was reduced to a cadre in December 1945 and disbanded on 10
April 1946.
The VAOC flag was a modified 72 by 36 inches Royal Air Force
Ensign with a yellow eagle superimposed on the roundel and V A O C in white
below the Union. The eagle's wingtips touched the roundel outer edge. The VAOC
letters were each 1.25 inches 'thick' and 5.5 inches high, with their upper
edges nine inches below the Union bottom edge. The roundel is smaller than
usual. It would have been 15.63 inches outer diameter and centred about
one-third of the fly width up from the flag's bottom edge. Drawings of this flag
include the note 'Normal Roundel' near the reduced-size RAF roundel. This
suggests that the size and position of the roundel on Australian RAF Ensigns was
changed, perhaps as a wartime 'austerity' measure to save bunting.
Jeff
Thomson, 10 November 2015
images by Nozomi Kariyasu, 10 April 2024
Used by both Royal Australian Air Force and Royal New Zealand Air Force as fin flash and based of one of the RAF flashes.
Dov Gutterman, 8 October 1999
Until 1942, standard RAF markings were used by the RAAF.
In order to avoid confusion with Japanese planes, the red was removed from the roundel and fin flash. See photo at https://www.airforce.gov.au/about-us/your-air-force/roundel. This roundel and fin flash were in use from June 1942 until 1946.
Regulations of 26 September 1956 replaced the red dot with red kangaroo, but only in 1982 was it also changed on the RAAF ensign.
Naval air arm and military aviation use the same marking.
Dov Gutterman, 11 June 2004
See also:
images by Nozomi Kariyasu, 12 May 2024
image located by Peter Hans van den Muijzenberg, 6 October 2010
This page
http://rides.webshots.com/photo/2792039430059648701SQsTYi has it
captioned as "Flag of the RAAF - Royal Australian Airforce".
Peter Hans van den Muijzenberg, 6 October 2010
We have seen mention of this flag previously and if I recall, its status
remains unclear. The Royal Australian Air Force (RAAF) continue to use their
traditional ensign (Australian flag with light blue field plus roundel).
Whilst I do not know the status of this roundel-flag, I suspect that it is used
in circumstances where there is an RAAF presence, but it is not appropriate to
use the RAAF ensign. The most logical example of such an occasion would be at an
Air Show or Trade Exhibition - and the roundel-flag has been created to act in a
manner equivalent to a company flag or similar flags made from corporate logos.
The RAAF is very protective of the copyright use of its emblems, so I suspect
that it does have some official authorisation by the RAAF. Accordingly, I think
we should regard this as an unofficial banner of the RAAF for use where a "brand
identity" is required, rather than the official ensign.
Ralph Kelly,
7 October 2010